More actions
Product Video
Product Picture
Product Description
- 2.2-inch color screen,support 16BIT RGB 65K color display,display rich colors
- 176x220 resolution, clear display
- Using the SPI serial bus, it only takes a few IOs to illuminate the display
- With SD card slot for convenient function expansion
- Provide underlying libraries and rich sample programs for Arduino, C51, and STM32 platforms
- Military-grade process standards, long-term stable work
- Provide underlying driver technical support
Product Parameters
Name | Parameter |
Display Color | 16BIT RGB 65K color |
SKU | MAR2201 |
Screen Size | 2.2(inch) |
Type | TFT |
Driver IC | ILI9225 |
Resolution | 176*220 (Pixel) |
Module Interface | 4-wire SPI interface |
Backlight | 3 White Led |
Active Area | 34.848x43.56 (mm) |
Module PCB Size | 42.46x67.20 (mm) |
Operating Temperature | -10℃~60℃ |
Storage Temperature | -20℃~70℃ |
Operating Voltage | 5V/3.3V |
Power Consumption | About 90mw |
Product Weight | About 25(g) |
Interface Definition
Number | Pin Label | Description |
1 | VCC | LCD Power positive (3.3V~5V) |
2 | GND | LCD Power ground |
3 | GND | LCD Power ground |
4 | NC | Not defined, reserved |
5 | NC | Not defined, reserved |
6 | LED | Backlight control, high level lighting,
if not controlled, connect 3.3V always brigh |
7 | CLK | LCD SPI bus clock signal |
8 | SDI | LCD SPI bus write data signal |
9 | RS | LCD register / data selection signal,
high level: register, low level: data |
10 | RST | LCD reset signal, low level reset |
11 | CS | LCD chip select signal, low level enable |
Product Documentation
- 2.2 inch Arduino SPI Module User Manual
- [ 2.2 inch Arduino SPI Module Size Picture]
- 2.2 inch TFT Specifications
- 2.2 inch Arduino SPI Module Schematic
- Driver IC ILI9225 Data sheet
Connect to Arduino
![]() |
![]() |
---|---|
Arduino UNO direct insertion picture | Arduino Mega2560 direct insertion picture |
How to use on Arduino
- Step 1: Download the test program
- Download the Arduino test program from the Program Download column
- For a description of the relevant test procedures, please refer to the test program documentation in the package
- Step 2: Connect the Arduino development board
- Plug the module directly into the Arduino development board ( Do not plug in?)
- After the module is plugged in, power on the Arduino board
- Step 3: Copy the dependent library
- Make sure the Arduino IDE is installed on your computer (if it is not installed: Arduino IDE download URL)
- After installing the Arduino IDE, you need to copy the dependent library to the Arduino project directory as follows:
- (1) Decompress the downloaded test package
- (2) Copy the dependent libraries in the Install libraries directory in the package (shown below) to the libraries folder
- of the Arduino project directory ( Don't know the Arduino project directory?)
- Step 4: Compile and download the program to the development board
- Open the sample in the Example directory of the package to test, compile and download( Don't know how to compile and download?)
- Step 5: Observe the running of the program
- After the program is downloaded, run it directly and observe the running status. If it can be displayed normally, the program runs
- successfully, as shown in the following figure (take the colligate_test test program as an example):
Program Download
Reference Materials
- Arduino IDE software use illustration
- C51 Keil and stc-isp software use illustration
- STM32 keil software use illustration
- PCtoLCD2002 software use illustration
- Image2Lcd software use illustration
- Chinese and English display modulo settings